Pen pressure changes too much based on angle of stylus?
Hello all, I need some help. I've been struggling with inconsistent pen size since moving over to Clip Studio Paint, and it's been very frustrating. It felt like brushes would randomly change size between brush strokes, and I had no idea why it was happening. I think I figured it out, it seemingly depends on the angle I'm holding my stylus. Both of these lines were drawn with the same brush (G Pen size 50). The top line was drawn while holding the stylus vertically, and it filled the entire circle instantly. The bottom line was drawn with the exact same pen, holding the stylus at an angle and pressing down on it as hard as I could. I understand that pressing down on the tip applies more pressure, and I want that, but this much of a degree of difference seems a bit too unreliable. Is there anything I can do to remedy this without disabling pen pressure altogether? I tested this on FireAlpaca and it seemingly did not repeat the same results, and I never remember feeling this with that program. Any help is massively appreciated.
Also please recommend me some crisp free pens on the asset store to make nicer lineart with thank you.
Hello all, I need some help. I've been struggling with inconsistent pen size since moving over to Clip Studio Paint, and it's been very frustrating. It felt like brushes would randomly change size between brush strokes, and I had no idea why it was happening. I think I figured it out, it seemingly depends on the angle I'm holding my stylus. Both of these lines were drawn with the same brush (G Pen size 50). The top line was drawn while holding the stylus vertically, and it filled the entire circle instantly. The bottom line was drawn with the exact same pen, holding the stylus at an angle and pressing down on it as hard as I could. I understand that pressing down on the tip applies more pressure, and I want that, but this much of a degree of difference seems a bit too unreliable. Is there anything I can do to remedy this without disabling pen pressure altogether? I tested this on FireAlpaca and it seemingly did not repeat the same results, and I never remember feeling this with that program. Any help is massively appreciated.
Also please recommend me some crisp free pens on the asset store to make nicer lineart with thank you.